ASE Home Page Products Download Purchase Support About ASE
ChartDirector General
 Forum HomeForum Home   SearchSearch

Message ListMessage List     Post MessagePost Message

  Can i connect point with each other on Scattered Data Contour Plot?
Posted by Luke on May-17-2015 01:20
| Reply | Monitor
Hello,

I made Contour plot and I need to display on it 3 points. Is there any way to connect them
with lines in the triangle?

Thanks for your help.

  Re: Can i connect point with each other on Scattered Data Contour Plot?
Posted by Peter Kwan on May-19-2015 01:36
| Reply | Monitor
Hi Luke,

Yes. You can add a line layer on top of the contour layer to create a triangle over the
contouer layer. In ChartDirector, the segments in a line chart can flow in any direction. An
example is at:

http://www.advsofteng.com/doc/cdnet.htm#xyline.htm

If the line layer has 4 points with the last point the same as the first point, it will form a
triangle. To ensure the line layer stays on top of the contour layer, please add the line layer
to the chart first, followed by the contour layer, or you can use Layer.moveFront to move
the line layer to the front.

Hope this can help.

Regards
Peter Kwan