ASE Home Page Products Download Purchase Support About ASE
ChartDirector Support
 Forum HomeForum Home   SearchSearch

Message ListMessage List     Post MessagePost Message

  which intercept is chartdirector using?
Posted by slaniwani on Jan-21-2011 00:26
| Reply | Monitor
Hi,

short question :

Which intercept is ChartDirector using with the call of layer.getIntercept() ?

I am a little bit confused of the result.

Is it the X Intercept or Y Intercept?

The Y intercept is the Y value of the line when X equals zero. It defines the elevation of the line, right?

  Re: which intercept is chartdirector using?
Posted by Peter Kwan on Jan-21-2011 01:08
| Reply | Monitor
Hi slaniwani,

It is the y-intercept (the value of y when x = 0).

Hope this can help.

Regards
Peter Kwan